Pages

Showing posts with label Samsung 840. Show all posts
Showing posts with label Samsung 840. Show all posts

Thursday, February 19, 2015

Samsung 840 series SSD after 2 years and 2 months

The warranty for my Samsung 840 series 250GB SSD has run out. It was purchased in December of 2012 and since it has TLC flash, Samsung only granted a warranty period of 3 years. Usually, you would get about 5 years for SSDs with regular MLC flash.

But does that mean the drive is close to die? Far from it! Despite the low number of erase cycles supported (1000 per flash cell) by the flash on these drives before they are unable to m, they are good hundreds of terabytes, or even thousands all thanks to the wear leveling employed by the controller.

In my case though, I am nowhere near hundreds of terabytes. In fact, I haven’t even crossed 10TB!!! As per Samsung SSD Magician, as of today, the total bytes written to the drive is only 9.89TB.

840 small

Samsung SSD Magician info

image

SSDLife Pro info

Wednesday, December 11, 2013

[Rant] Samsung 840 usage after almost a year

It's been almost a year since I've bought the Samsung 840 series SSD for my rig. Since this has TLC flash, it should deteriorate quickly. So I have been keeping a close eye on the amount of data written to the drive.

3.96GB after about 330 days. That’s 12GB/day. Quite a lot more than I expected, to be honest.

Samsung_Magician_2013-12-11_07-10-06

According to this article at Anandtech, it seems at 10GB data written per day, a 256GB drive should last for 70 years! So maybe mine will last for 58 years. No big deal. I will be dead by then.

Need to load it up more.

[Rant] Samsung 840 Pro finally supports Rapid Mode but no love for 840 non-pro

When Samsung released the 840 EVO, it introduced this new feature called Rapid mode where the SSD could use a portion of RAM as a super fast cache for the SSD to speed up reads and writes. At that time, only the 840 EVO family of SSDs supported this feature. There were rumors that this feature would eventually come to the other two models of the 840 family, the 840 Pro and the 840 non-Pro.

Yesterday Samsung updated their Samsung Magician software to bring Rapid mode to the 840 Pro family of SSDs. All you have to do is install Samsung Magician version 4.3. If you already have an older version installed, you will be prompted to update when you launch it.

It is nice that Rapid Mode doesn’t need a firmware update.

Samsung_Magician_4.3

But that makes me wonder, why isn’t the 840 non-pro supported? If it can be done by just updating their Magician software, they could bring this feature to the 840 non-pro models without any problems, right? Does that mean these drives are never going to get the Rapid Mode? That would really suck!

Friday, June 7, 2013

Intel Rapid Storage Technology 12.5 is faster than 11.7

Remember I recently upgraded the firmware on my Samsung 840 series 250GB SSD? Even though the release notes said that I would see some performance improvements with the DXT08B0Q firmware, I didn’t see any. Then I upgraded the Intel Rapid Storage Technology drivers to see if it yielded in any improvements.

I originally had version 11.7.0.1013 installed. This was what I had when I flashed the firmware. There was a newer version out when I checked it a few days ago. Version 12.5.0.1066 (download from here). I don’t know what happened to version 12 though. Maybe I didn’t check for a new driver in a while. I only got to know that there was a newer driver from OCN forums.

I first uninstalled the old driver and installed the new one, just to be sure. Updating drivers doesn’t go really well most of the times. Ironically, I always update the NVidia drivers, never uninstall the old one and install the new one. I do that because I haven’t had issues doing so in the past. Sorry, I digress.

BTW, I downloaded the floppy driver, not the Windows drivers. The floppy driver comes with… just the RST driver. But the Windows driver comes with their monitoring and management software as well. Since I don’t use Smart Response Technology or RAID in my PC, there is no need to install them. No need to add more junk to the PC. I want to keep it as clean as possible.

Here are the benchmarks, before and after the update. Both were done after I updated the firmware to DXT08B0Q. For the entire specs of the test rig, click here.

Before (11.7.0.1013)

as-ssd-bench Samsung SSD 840  2013-06-01 8-54-44 AM

After (12.5.0.1066)

as-ssd-bench Samsung SSD 840  2013-06-01 8-58-47 AM

So you see, there is nice speed bump after the driver update. I don’t think that is a noticeable difference. Heck, you cannot feel the difference between two SSDs to the naked eye, without running benchmarks anyways. I just got this SSD because it was the cheapest 250GB one available back in January. not because it is the fastest.

Wednesday, June 5, 2013

Samsung 840 series 250GB Firmware Update: DXT08B0Q Benchmarks

Samsung released a new firmware for the Samsung 840 series (Pro and non-Pro both) few days ago. I didn’t upgrade that instant, because I saw on OCN forums that few people were having issues with the new firmware. I don’t want to end up with a dead drive. I don’t have a spare SSD lying around. Wish I kept that old SSD with me just in case something went wrong with the new one. But I didn’t and there is no point regretting about it. Have to move on.

But today I gave in, and went ahead with the update. What made me confident that something bad might not happen is because Samsung hadn’t pulled the firmware. That means there is nothing wrong with it to begin with. The people who got bad outcomes must have done something stupid. Just to be safe, I killed all the apps running in the foreground as well as background before starting the firmware update process.

I had DXT07B0Q firmware before update. You have to use Samsung SSD Magician software to do the firmware update. Even without me checking for an update manually, it automatically detected that there was a newer firmware available and highlighted in the UI of the software. Nothing amazing. That’s the way everything should work these days anyways. Just wanted to say that it is working as if should.

2013-06-01_08-50-34

Everything went smooth. It didn’t take long, and once done, the software told me that it needs to shutdown the PC to finish the update. What I didn’t know was that it would not automatically reboot. It was a clean shutdown, not a reboot. Some people might be confused by how it happened. With the previous drive, all that was required was a reboot. Anyways, now I know how it works in the future.

So did I see any gains with the new firmware? No! None at all. I recorded some benchmark scores on AS-SSD before and after the firmware update. Before running the test, I optimized the drive using the Magician software. Here are the results.

Note: Both tests were run with Intel Rapid Storage Technology ver. 11.7.0.1013 drivers.

Before update ( ver. DXT07B0Q )

as-ssd-bench Samsung SSD 840  2013-06-01 8-48-37 AM

After update ( ver. DXT08B0Q )

as-ssd-bench Samsung SSD 840  2013-06-01 8-54-44 AM

As you can see, the scores are identical. The difference would be attributed to measurement error. Well, at least the performance didn’t go down. That’s a relief.

Thursday, March 28, 2013

Samsung 840 series 250GB SSD–after couple of months

So I’ve been happily using my new SSD without any hiccups….wait! There was one hiccup where the Windows Experience Index score dropped from 8.1 to 7.9. That sucked, because that was what I was getting with my old Kingston HyperX 120GB SSD too. I was expecting this SSD to perform faster throughout the entire lifespan. Dropping to the same grounds obviously made me feel very sad.

But luckily, I was able to get back the lost performance by running the Performance Optimization function of Samsung Magician software. I don’t know exactly what it does, but it should not be something extensive because whatever it did finished within few seconds.

According to the health monitor, I have written 0.8TB of data to this drive. That’s a little of 11GB per day. That’s a lot, right? Maybe I should stop using the fast start functionality of Windows 8 which saves the kernel to the hiberfile.sys when you turn the PC off. That means, you don’t have to reload everything from the scratch. That would save like 1-2 seconds of Windows boot time – no big deal – the SSD is more important, right?

Drive health status in Samsung Magician software

image

Wait. I’m getting ahead of myself. So, 11GB per day means, it takes about 14 days to completely fill the “remaining” cells (the actual capacity of 256GB – 100GB used = 156GB remaining / 11GB per day). Two weeks. TLC flash on this drive can be rewritten up to 3000 times. At the current state, the drive should be able to live for 3000 of two weeks, meaning more than 100 years!!!

OK, I’m gonna keep Fast Start enabled because time matters…even those couple of seconds which you won’t even notice because the PC would be already booted up by the time you come back to the PC.

S.M.A.R.T information

image

I have no idea how to read these values, but since everything is OK, I’d not worry about it any further.

Thursday, February 14, 2013

How to improve/restore your Samsung 840 Series SSD’s performance

Remember that I bought a Samsung 840 series 250GB SSD about a month ago? Remember also that I told you I would be closely monitoring the degradation? This is the report after a month of moderate use.
 
On a fresh Windows 8 Pro x64 installation, the Windows Experience Index rated the SSD at a score of 8.1. But over the past month, I installed a lot of applications and huge games and now the SSD is 30% full. (Yeah, just 30%!) Once even I mistakenly copied my entire iTunes music collection to the SSD. Then I downloaded a whole 10GB file to the SSD without knowing that it was being downloaded into the SSD. I also did not do any of the space-saving tricks discussed here either. I'm using the default temporary folders. However, I do not let those temporary folders to fill up. Everyday at 10PM, a scheduled CCleaner cleanup job gets executed and all the temporary files get purged.
 
2013-02-13_23-37-41

The Windows Experience Index score for the SSD quickly dropped to 7.9 after a couple of weeks. I wasn't happy about it because that's what I got with my old SSD as well. I waited a week or so hoping that the original performance would be automatically restored, but it didn't happen. I felt as if I was cheated.
 
The SSD comes with a maintenance / management tool called the Samsung SSD Magician.
 
2013-02-13_23-35-08
 
You can perform various tasks in it.
  • Benchmarking (Sequential read/write speeds + IOPS)
  • Performance Optimization (garbage collection?)
  • Data migrating (cloning from a old drive)
  • Secure erasing (resetting the bits either to start fresh - kinda like a manual trim, if you are going to sell the drive.)
  • Changing the amount of default over provisioning (how much space is reserved for wear leveling)
  • Optimizing the OS settings to get the best out of the SSD (things like disabling indexing service and hibernation)
  • Firmware update

I'm not actually sure what Performance Optimization does, perhaps some sort of garbage collection, but that is what we are interested in. Last night I ran it to see if I can get back the score of 8.1 in Windows Experience Index. It didn't take long. It originally predicted a running time of 6 minutes, but it actually finished within a minute. Thus I wasn't expecting any miracles. But that's what I got. A miracle.

Monday, January 14, 2013

Samsung 840 series 250GB SSD benchmarks

Finally, it is time to post some benchmarks of my new Samsung 840 series 250GB SSD. I got this for a cheap JPY13,524 which was cheaper than the regular price due to holiday promotions. I am using this drive entirely for the OS (Windows 8 Pro), programs and games. Since I have ample amount of space in this drive, finally I’m using a pagefile (albeit smaller than the recommended size because I have a lot of RAM anyways) and also using the SSD for the temporary files. (However, I do clean up the temporary files at every boot using CCleaner.)

I wasn’t sure whether to use hibernation with this drive. The reason to use hibernation (or the hiberfile.sys) is to speed up boot up even further, making use of fast boot. Currently I am not using it, but I will experiment with it later. Perhaps it will fix the slow load up of system tray applications in Windows 8.

Photo-shoot

Package

IMG_1203

IMG_1204

IMG_1205

Tuesday, December 18, 2012

Which SSD to get? Samsung 840 Pro or OCZ Vector? Or something not thathighend?

Edit:
Since then I have bought the Samsung 840 Series 250GB SSD because it was the cheapest drive I could find and it indeed is fast enough for everything I want it for. Head HERE for some benchmarks folks.

To the original post then...

OK. Now that I have replaced the hard drives (link and link), it is the phase 2 of my plan. It's time to replace my Kingston HyperX 120GB SSD.
 
Why replace the current SSD?
 
1. Number one reason is that I have to give someone a cheap SSD and instead of buying a smaller (probably used) SSD, I can give mine away. For someone getting his first SSD, 120GB is a big deal. Besides, I have maintained this SSD very well. Since the resale value of a second hand SSD is pretty low, I'm taking this chance to refresh a new toy.
 
2. I will soon have JPY 10,000 worth points from sofmap.com by trading in my old HDDs , so I'd like to use them on a new toy. I don't have to use then right now though.
 
3. I have had instances where 120GB is just not enough. I've managed to avoid unpleasant scenarios but it won't hurt to have more space. The only problem I have is that there is a very good chance that the prices would come down in the next year. I might be able to buy 512GB for the same amount of money I spend today on a 256GB high-end SSD like the Samsung 840 Pro. That's a chance I have to take. Maybe this single point will hold me off from buying an SSD right now.

Related Posts Plugin for WordPress, Blogger...